|
The Artemis Labs SP-1 Stereo Power Amplifier is a no-compromise purist
design. It is designed to get the
most from the “super 300Bs” such as the KR 300BXLS and Full
Music 300B+, delivering from 13 to 18 watts
(depending on the tube type) of clean single-ended power. Careful power
supply filtering and regulation of
critical voltages ensure stable, quiet operation. All aspects of the
design were done by John Atwood of One
Electron™.
Given that the SP-1 amplifier puts out about 15 watts
per channel, it must be used with relatively efficient
loudspeakers. The minimum efficiency required depends on many factors
including room size, room absorbtion,
preffered listening levels, etc., but in general, an efficiency of
90dB or higher per watt at 1 meter is
needed. Work with your dealer for the best speaker combination for
your listening set-up.
Stereo power amplifier on two chassis:
stereo amplifier and power supply.
Power output per channel before clipping:
14 Watts rms
Output impedances available:
4 and 8 ohms
Frequency response at 10 Watts output:
20Hz to 35KHz +/- 1dB
Maximum THD distortion before clipping:
3%
Input impedance:
100K
Input sensitivity:
0.8Vrms for full output power
Power consumption:
525 Watts
Line voltages available:
100, 110, 120, 220, 230, 240V (selected at factory), 50 or 60Hz
Input Impedance: 100K ohms.
Power Gain: 0.7VRMS in for 10W out (1KHz)
Frequency Response & Distortion: (measured with KR 300BXLS tubes)
 1 Watt Output:
Frequency Response: 14Hz – 38KHz ± 1dB
THD+N at 1KHz, < 0.5%
10 Watts Output:
Frequency Response: 15Hz – 35KHz ± 1dB
THD+N at 1KHz, < 1.5%
Output for 5%THD (1KHz): 13 to 18W,
depending on output tube
Damping Factor: (1KHz, 5W): 4.8
Output Noise: (grounded input, 8 ohm output into 8 ohm load, rms
detector):
22Hz - 30KHz: < -88dB below 10W output
“
A-weighted”: < -105dB below 10W output
Crosstalk:
1KHz: < -81dB
20KHz: < -57dB
Mains Voltage: Wired at factory for one of the following voltages:
100, 110, 120, 220, 230, 240V, 50 to 60Hz.
Power Consumption when powered-off (rms): 2.3 Watts nominal
Power Consumption when powered-on (rms): 340 Watts nominal
Size:
Power Supply Chassis: 9 ½" (241
mm) Height, 12 ¼" (311
mm) Width, 13 3/8" (340 mm) Depth
Amplifier Chassis: 9 ½" (241 mm) Height, 12 ¼" (311
mm) Width, 16 3/4" (425 mm) Depth
Mass: Power Supply Chassis: 51 lbs. (23.2Kg)
Amplifier Chassis: 55 lbs. (25Kg)
Specifications measured with KR 300BXLS tubes installed
Full specification to be released
MSRP: $18,000 USD
|
